Install the tube lights LED is a great way to save money on energy and potentially hazardous fluorescent lighting in your home or office. It can, however, the LED lights now on the market longer tube not only are installed directly into an existing fluorescent lamp. Need to make some simple changes in the support for proper installation of the lamps. The good news is that the installation of a fluorescent tube, LED fluorescent light in an existing device is relatively simple. You can alsoShould be able to devices specifically designed for LED lighting tube developed in the near future to buy, and should actually be cheaper than the equivalent fluorescent. This article aims to explain a brief overview of what you need to know to install the new energy saving fluorescent tubes in an existing fluorescent lamp.
Fluorescent lamps are designed to support a certain type and size of the fluorescent tube. A fluorescent tube is integrated in aFluorescent lighting system with two or three components: (1) fluorescent lamps (fluorescent tubes or pipes), (2) of the ballast, and (3) Goodwill. In addition, the system for a lamp tube, a lamp and a switch. Depending on the particular system a fluorescent lamp, the starter is a replaceable component, a starter is not needed, or the start function can be integrated into the gravel. The function of starting point can also count on the physicalLamp design. For the adaptation of a fluorescent lamp, a fluorescent tube LED, the ballast (and the starter, if one is available separately) support, must be separated.
Make sure the LED lights to replace the pipe the right size for the device. Also, always remember that in the maintenance of a fluorescent bulb or for any reason, electric power, the holder entire being disconnected. This is not always practical in situations where a large number of fasteners arecontrolled by the same power control (such as open office areas). In these cases, gloves and a non-metallic conductors are used when the equipment must be maintained if power is available.
You need a couple of simple tools, including a wire stripper and a wire (often the same tool are included), a pair of pliers, a screwdriver and a pair of cable connectors to reconnect the wires when you removed the ballast .
After the bulbs are removed from older versionsand the current for the device is switched off, probably on the reflector, which is located behind the lights and provides a space for wiring and ballast, which are located behind removed. It's usually pretty easy to cover or remove the reflector, but it is not clear how to do this, you should consult the manufacturer's documentation bracket.
If the device has an electronic ballast, just remove that and then connect the power directly to the lampOwner, completing a circuit for each bulb. This is quite simple, and usually you can use the existing cable in the bracket and then just add a little 'cable connectors. If you have an old machine with a magnetic ballast and starter, remove or open the starter and remove the short or magnetic ballast.
Depending on how much yarn to work with, it's a good idea to have enough back along the wires from the ballast to be able to ballast with protective caps, ifYou should always want to convert the rear unit for use fluorescent tubes or want to use the ballast somewhere else. Typically, the reactor will have two screws or bolts that hold the bracket in place, and can be with a screwdriver or pliers, as appropriate. The ballast is made in accordance with local regulations and the old fluorescent tubes are eliminated. Because fluorescent tubes contain a small amount of mercury is highly toxic, must be treateddisposed of as hazardous waste, and as a result.
Once the ballast (starter and, if it was present) were removed and can completely replace the cables back to a circuit for each lamp or reflector the wiring and cover the area where the dirt was, and LED lights on the hose connectors are connected. Unlike fluorescent tubes, which is not an up or down, an LED fluorescent tube has a clear top and bottom, with a metallic heat sink on the backthe tube and the LEDs are visible under a lens the privileged side, on the surface to be illuminated. Put the lid on the device (if there was one), turn the tide. Turn on the switch, and if you did everything correctly, you should have as good or better lighting with about half the electricity and lasting as long as 50,000 hours or more.
0 comments:
Post a Comment